|
| |
| Welcome to myHanse.com the forum for Hanse Yachts owners throughout the world. | |
Required clearance height for rudder removal |
Post Reply 
|
| Author | |
martijnvdh 
Commander 
Joined: 25 August 2021 Location: Belgium Status: Offline Points: 110 |
 Post Options
 Thanks(0)
 Quote Reply
 Topic: Required clearance height for rudder removalPosted: 30 May 2023 at 15:32 |
|
In preparation for next winter's maintenance, and to be able to discuss with the yard:
Does anybody know how much height is required between bottom tip of the rudder and the ground to allow the 371's rudder to be removed? Many thanks!
|
|
 |
|
|
Mark_J1
Rear Admiral 
Joined: 12 March 2013 Location: Dover&Medway UK Status: Offline Points: 690 |
Post Options
Thanks(0)
Quote Reply
Posted: 19 June 2023 at 22:25 |
|
If it's a similar Jefa steering setup to the 400 (1.98m draft), then FYI with the boat in a cradle adding about 30cm to the overall draft there was plenty of room to drop and remove the rudder. The bottom bearing rotates about the vertical in its 'cup'. So it helps that the rudder can slide out with a small lean backwards limited only by the diameter of the rudder tube.
Mark
|
|
|
Hanse 400e "Grey Goose" Hull #31
|
|
|
|
|
martijnvdh
Commander
Joined: 25 August 2021 Location: Belgium Status: Offline Points: 110 |
Post Options
Thanks(0)
Quote Reply
Posted: 20 June 2023 at 07:39 |
|
Thanks Mark - yes, I believe the setup to be very similar if not equal to the 400.
|
|
|
|
|
Post Reply
|
|
| Tweet |
| Forum Jump | Forum Permissions You cannot post new topics in this forum You cannot reply to topics in this forum You cannot delete your posts in this forum You cannot edit your posts in this forum You cannot create polls in this forum You cannot vote in polls in this forum |
|
Links : www.hanseyachts.co.uk www.hanseyachts.com www.fjordboats.co.uk www.dehler.co.uk www.varianta.co.uk |
Topic Options