|
| |
| Welcome to myHanse.com the forum for Hanse Yachts owners throughout the world. | |
Yanmar B-type Panel Alarm Buzzer on / off? |
Post Reply 
|
Page <12 |
| Author | |
Issywa 
Commander 
Joined: 13 April 2022 Location: Seattle Status: Offline Points: 143 |
 Post Options
 Thanks(0)
 Quote Reply
 Posted: 21 October 2024 at 04:57 |
|
Wondering how you folks are removing the water sensor for testing? Mine is not interested in being removed and I'm concerned that I will break it if I apply too much pressure.
|
|
 |
|
|
cptgood
Commadore 
Joined: 26 August 2016 Location: Tuscany - Italy Status: Offline Points: 454 |
Post Options
Thanks(0)
Quote Reply
Posted: 22 October 2024 at 13:21 |
|
It must be unscrewed
|
|
|
Hanse320 - Hull#127/08 - Wheel - ST headsail - Yanmar 3YM30 - SD20
|
|
|
|
|
Issywa
Commander
Joined: 13 April 2022 Location: Seattle Status: Offline Points: 143 |
Post Options
Thanks(0)
Quote Reply
Posted: 22 October 2024 at 19:18 |
|
Yup - I understand it needs to be screwed out. But when I try, it won’t budge and I am concerned about applying too much force and breaking it.
|
|
|
|
|
brianworrall
Sub Lieutenant 
Joined: 10 July 2025 Location: UK Status: Offline Points: 1 |
Post Options
Thanks(0)
Quote Reply
Posted: 10 July 2025 at 22:19 |
|
My oil light on this green panel keeps flickering red. An engineer has tested the oil pressure and it is OK and the wiring to the panel also OK. How can i locate and fix an error on the actual alarm board. A new one is a crazy price?
|
|
|
|
|
Issywa
Commander
Joined: 13 April 2022 Location: Seattle Status: Offline Points: 143 |
Post Options
Thanks(0)
Quote Reply
Posted: 17 November 2025 at 14:57 |
|
As a follow up to my earlier post, I recently serviced my sail drive and took the opportunity to check the water sensor. Even with the sail drive out of the boat, I was unable to remove the sensor in one piece. I had to use a fair bit of force and sheared off the plastic top. I then drilled a couple of small holes in it and was finally able to remove it in several pieces. The threads looked like “glue” had been used when it was installed.
|
|
|
|
|
Post Reply
|
Page <12 |
| Tweet |
| Forum Jump | Forum Permissions You cannot post new topics in this forum You cannot reply to topics in this forum You cannot delete your posts in this forum You cannot edit your posts in this forum You cannot create polls in this forum You cannot vote in polls in this forum |
|
Links : www.hanseyachts.co.uk www.hanseyachts.com www.fjordboats.co.uk www.dehler.co.uk www.varianta.co.uk |
Topic Options