Print Page | Close Window

Electronic Control Panel

Printed From: myHanse.com
Category: General
Forum Name: Cruising
Forum Description: Chat about Cruising
URL: https://www.myhanse.com/forum_posts.asp?TID=12206
Printed Date: 27 March 2026 at 01:23
Software Version: Web Wiz Forums 12.06 - https://www.webwizforums.com


Topic: Electronic Control Panel
Posted By: DHE @ 01945
Subject: Electronic Control Panel
Date Posted: 11 September 2020 at 16:03
How do I disable alarm function on Wurth TEV 0605 panel?  Low water level alarm consistently on and not able to monitor other functions?



Replies:
Posted By: Breeze On
Date Posted: 11 September 2020 at 23:52
Looks like a 3sec press of the “enter” key...

6.2 SensorError
It is a prerequisite for an error checking that the sensor is configured as “ENABLED” (see Figure 3 configuration).
The signals of the sewage, water and diesel sensors and the battery voltage are compared to the configured min / max values. In the event of a lower deviation or overriding the main menu jumps to the sub-menu. In addition to the bar chart a blinking “!” also indicates the incorrect value.
In this state the cursor key or cannot change to a different menu. Only the following is possible:
.
a) Short confirmation of the enter key to jump to the min / max setting menu.
b) If the enter key is pressed for a duration of at least 3 seconds, the main menu is accessed. If several different sensor errors occur at the same time, these will also be automatically confirmed.
Inaccurate values will then be indicated by a blinking „ ! “.
Alarm terminable?
                                                          


-------------
George & Bev

Breeze On (415 #096)


Posted By: Matt
Date Posted: 12 September 2020 at 00:03
Not unless the issue is addressed. “Silencing” the alarm as described is the only option I’m aware of. If you have a faulty sensor then probably the only way is to disable “water” as a monitored item until resolved.

-------------
HANSE 445 #231 "ALBION"


Posted By: Persephone
Date Posted: 12 September 2020 at 13:37
The  problem I ran into is that if the water in the tank is sloshing around silencing the alarm may only work for a few seconds before it re-alarms. I no longer use the Wurth panel for tank monitoring.


Posted By: DHE @ 01945
Date Posted: 13 September 2020 at 17:15
Thanks all!
Problem solved by disabling Freshwater Sensor from panel (press and hold up arrow and down arrow and enter functions simultaneously, then scroll to "Freshwater" and scroll down to DISABLE and enter... will enable angain after water hose repair and tank fill (which was underlying source of alarm display).



Print Page | Close Window

Forum Software by Web Wiz Forums® version 12.06 - https://www.webwizforums.com
Copyright ©2001-2023 Web Wiz Ltd. - https://www.webwiz.net