Adjust Barka Electric Pedestal Table Height?
Printed From: myHanse.com
Category: General
Forum Name: Chit Chat
Forum Description: Talk about anything to do with your boat
URL: https://www.myhanse.com/forum_posts.asp?TID=15190
Printed Date: 26 March 2026 at 23:37
Software Version: Web Wiz Forums 12.06 - https://www.webwizforums.com
Topic: Adjust Barka Electric Pedestal Table Height?
Posted By: Ananda
Subject: Adjust Barka Electric Pedestal Table Height?
Date Posted: 16 June 2025 at 17:46
|
On our 460, we have a saloon mounted electric table that does not go down far enough so that table cushion is same height as sofa cushions. It is off by about 30mm. Is there a way to adjust the lower height limit? Thanks! William
|
Replies:
Posted By: Ananda
Date Posted: 08 July 2025 at 17:41
|
bump ------------- Hanse 460 2022 "Ananda" Annapolis Maryland USA |
Posted By: Lyn
Date Posted: 09 July 2025 at 13:16
|
Hmm. Can you post a picture of it in the lowered position from the side? Don't stand and take the picture. I'd like to see if the 3 cylinder sections telescope completely so that the plate that attaches to the table top is on top of the largest diameter that attaches to the cockpit floor.
------------- Jon S/V Lyn 2017 Hanse 588 | Hull 19 | Deep draft | 150hp | 220v & 110v systems | Lithium House Bank |
Posted By: Ananda
Date Posted: 09 July 2025 at 15:28
|
Will do tomorrow night when I get to the boat. Thanks! ------------- Hanse 460 2022 "Ananda" Annapolis Maryland USA |
Posted By: Ananda
Date Posted: 10 July 2025 at 23:48
Photos of pedestal raised and lowered to full stops  ------------- Hanse 460 2022 "Ananda" Annapolis Maryland USA |
Posted By: Arcadia
Date Posted: 11 July 2025 at 02:47
|
It looks fully retracted to me. On the 588, Hanse provided a thin cushion for the table top so that the surface level matches the seats. ------------- Leon / ARCADIA 2018 Hanse 588 Sag Harbor, NY |
Posted By: Arcadia
Date Posted: 11 July 2025 at 03:08
|
You can consider removing the plywood spacer that is between the lift and the table bottom. I’m sure it will be fine attaching the base directly to the table. That will give you an extra 25 mm or so. ------------- Leon / ARCADIA 2018 Hanse 588 Sag Harbor, NY |
Posted By: Gale Force
Date Posted: 11 July 2025 at 08:12
|
My table is attached directly to the plate and all fits nice and snug.That spacer looks like a bit of an afterthought Cheers Duncan
|