| |
| Welcome to myHanse.com the forum for Hanse Yachts owners throughout the world. | |
Engine heating problems |
Post Reply
|
Page <1 234 |
| Author | |
superliga
Rear Admiral
Joined: 25 April 2008 Location: Copenhagen Status: Offline Points: 590 |
Post Options
Thanks(0)
Quote Reply
Posted: 11 May 2013 at 17:17 |
|
Dragör is very nice and cosy you can go by bus to the center.
Kastrup, close to the new seacenter of Copenhagen. Langelinie if you want to be very close to the center but have a quiet stay. Nyhavn if you want to be in the center and walk 5 meters for cool beers. Chritianshavn, opposite from Nyhavn mooring between the houses and close to Christiania if you like a joint ![]() You can also moore right outside the queens palace. But there are no facilities e.g. water, power, toilets etc. There are lots of other harbours but these are the ones that springs to mind. Have fun! Edited by superliga - 12 May 2013 at 06:53 |
|
|
PEARL - S/Y SUPERLIGA - HANSE 470 e - Hull #168 - hanse470.com
|
|
![]() |
|
sailkoop
Commadore
Joined: 02 September 2010 Location: Germany Status: Offline Points: 437 |
Post Options
Thanks(0)
Quote Reply
Posted: 12 May 2013 at 15:33 |
|
Hi Pearl,
thx for the Information!! |
|
|
best regards
Bjoern |
|
![]() |
|
tobo
Captain
Joined: 01 February 2006 Location: Switzerland Status: Offline Points: 263 |
Post Options
Thanks(0)
Quote Reply
Posted: 12 May 2013 at 19:35 |
|
Another hint in case you have engines problems. Watch your freshwater
level. If you loose water first check whether the water is collected
under the engine or just not visible. The second is the worse case
because it could mix with your engine oil (gasket replacement
necessary). But most probably you have a leakage at the inlet opening as
this is according to my Yanmar technician a common cause: the
connection between the engine head (cast) and the inlet "neck" (steel)
can leak as it is another material. It's a minor repair that can be done
with epoxy two component type or by solding.
Generally I suggest to have done all repairs by a certified Yanmar or Volvo specialist. You may all be good at changing impellers or gaskets but remember your engine is the heart of your boat; if it fails you have a whole bunch of problems. ![]() |
|
|
Thomi
|
|
![]() |
|
Post Reply
|
Page <1 234 |
| Tweet |
| Forum Jump | Forum Permissions ![]() You cannot post new topics in this forum You cannot reply to topics in this forum You cannot delete your posts in this forum You cannot edit your posts in this forum You cannot create polls in this forum You cannot vote in polls in this forum |
|
Links : www.hanseyachts.co.uk www.hanseyachts.com www.fjordboats.co.uk www.dehler.co.uk www.varianta.co.uk |