|
| |
| Welcome to myHanse.com the forum for Hanse Yachts owners throughout the world. | |
No tank or.engine data on b&g chartplotter |
Post Reply 
|
Page 12> |
| Author | |
Lhsrris218 
Commander 
Joined: 26 September 2021 Status: Offline Points: 108 |
 Post Options
 Thanks(0)
 Quote Reply
 Topic: No tank or.engine data on b&g chartplotterPosted: 29 December 2024 at 20:27 |
|
Hi. Just a few b&g chartplotter questions
How do I get fuel and water tanks to show up? Where can I get polars for elvestrom sails (was supposed to be quantum fast As of now - laylines don't work and seem to point dead to wind on starboard tacks. Also - how do you dim the cockpit lights? Thanks so much! |
|
 |
|
|
mr-ludi
Captain 
Joined: 25 September 2022 Status: Offline Points: 152 |
Post Options
Thanks(0)
Quote Reply
Posted: 29 December 2024 at 20:36 |
Just a few weeks ago, I have installed a dimmer for the hardtop lights. Works perfectly. I bought this one: https://camperelektrik.de/products/dimmerkabelsatz-inkl-dimmer-kaby
|
|
|
|
|
marsella
Rear Admiral 
Joined: 21 June 2022 Location: Antigua Jolly H Status: Offline Points: 592 |
Post Options
Thanks(0)
Quote Reply
Posted: 29 December 2024 at 21:43 |
There should be a micro-c slot at the back of the DC panel, connect it with empty simnet slot around nav.table area and then go to chartplotter->network to see if the Wurth panel is recognized by MFD
Edited by marsella - 29 December 2024 at 21:44 |
|
|
|
|
Lhsrris218
Commander
Joined: 26 September 2021 Status: Offline Points: 108 |
Post Options
Thanks(0)
Quote Reply
Posted: 29 December 2024 at 22:17 |
|
The panel is a simarine unit.
|
|
|
|
|
marsella
Rear Admiral
Joined: 21 June 2022 Location: Antigua Jolly H Status: Offline Points: 592 |
Post Options
Thanks(0)
Quote Reply
Posted: 29 December 2024 at 22:29 |
|
Suspect very similar procedure applies to simarine panels
|
|
|
|
|
Lhsrris218
Commander
Joined: 26 September 2021 Status: Offline Points: 108 |
Post Options
Thanks(0)
Quote Reply
Posted: 30 December 2024 at 00:49 |
|
Only see an empty nmea2000 connector. Uses a proprietary can bus to communicate with its relay panel. I guess I'll try adding it to the nmea network and see what happens.
|
|
|
|
|
marsella
Rear Admiral
Joined: 21 June 2022 Location: Antigua Jolly H Status: Offline Points: 592 |
Post Options
Thanks(0)
Quote Reply
Posted: 30 December 2024 at 00:54 |
|
Yes nmea uses micro-c
|
|
|
|
|
voiceman1uk
Lieutenant 
Joined: 21 October 2021 Status: Offline Points: 24 |
Post Options
Thanks(0)
Quote Reply
Posted: 09 January 2025 at 07:40 |
|
I connected the Simarine panel to NMEA network and are able to see fuel and water tanks, only problem I experience is once in a while the Simarine panel locks up and the only way I have found to clear it is to switch off the batteries from a min
|
|
|
|
|
Lhsrris218
Commander
Joined: 26 September 2021 Status: Offline Points: 108 |
Post Options
Thanks(0)
Quote Reply
Posted: 16 January 2025 at 00:35 |
|
Hi. Following up on this.
My simarine panel is connected to ethernet already. I bought a micro-c cable to hook up the simnet but there isn't a "T" anywhere close by. Shouldn't the chartplotter see it already on the ethernet network?
|
|
|
|
|
voiceman1uk
Lieutenant
Joined: 21 October 2021 Status: Offline Points: 24 |
Post Options
Thanks(0)
Quote Reply
Posted: 18 January 2025 at 08:05 |
|
Not sure on the layout of your yacht but I bought an in line NMEA T connector and you should find an NMEA cable behind the FM radio (in that area) just connect it there and then run a cable to the back of the panel …not sure what you mean Ethernet cable
|
|
|
|
|
Post Reply
|
Page 12> |
| Tweet |
| Forum Jump | Forum Permissions You cannot post new topics in this forum You cannot reply to topics in this forum You cannot delete your posts in this forum You cannot edit your posts in this forum You cannot create polls in this forum You cannot vote in polls in this forum |
|
Links : www.hanseyachts.co.uk www.hanseyachts.com www.fjordboats.co.uk www.dehler.co.uk www.varianta.co.uk |
Topic Options
Lhsrris218 wrote: